It is also possible to read and transmit configuration strings without interpreting them. Sending Configuration Strings From Host Insert the screw into the strain relief and tighten to fix the whole assembly to the reader handle. To exit from this command, reset the system by cycling power to the Master cradle. In the following descriptions the completed transmission is indicated by the Beeper Control for Radio Response parameter with its default setting to Normal, see par.

Uploader: Gurisar
Date Added: 6 September 2007
File Size: 14.89 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 34152
Price: Free* [*Free Regsitration Required]

If reading different codes belonging to the same family, information about the last code will overwrite the information about the previous one.

Batch mode can be enabled drsgon manually normal batch mode or automatically. The message field can store plain text and escape sequences. Conversion Dragoon Code 39 d Series Only When the gun returns in range, transmission of the codes to the base station resumes automatically, according to the selected communication protocol, upon simply pressing and releasing the trigger or by successfully reading a new code.

Make sure that all cradles used in the same area have different addresses. Drxgon Warning Message The Master cradle can transmit warning messages to the Host regarding some network errors. These Special Keys can be used for: Remove the protective plastic from the rubber feet and stick them onto the bottom surface of the base.


You will need two ESC E commands to step from one row to the next when using the large font. If the timeout expires, the resulting action will be based on the following selection.

If the user gives up, he does not know if the transaction was successful. All cradles used in the network must have different addresses.

Datalogic Dragon D131 – Barcode Scanner

All codes are read ignoring the check digit. The resulting effects of this parameter on code reading depend on other related configuration conditions. To avoid excessive voltage drop, it is recommended not to propagate power between OM cradles drafon used as battery chargers but to supply each cradle individually.

To rapidly configure your point-to-point application: Serial Trigger Lock Dispose of the batteries as required by the relevant laws in force. However, the maximum number of cradles in a single network is 16, including the Master if present.

Two basic conditions must be met before the device is ready, the correct USB driver must be loaded and sufficient power must be supplied to the reader. Inclined Base Wall-mounting 6.

The adjustment can be different for each enabled code type. When this method is used, the programming sequence format is the following: It changes the way the Alt Mode procedure is executed, therefore it should be set as follows: Follow the given procedure: Read the following code to save the configuration automatically and return to the reader’s normal functioning: Insert the strain relief into the cover.

  HP 10 100TX DRIVER

To change the defaults see par. Actually the transmission could have been successful but the cradle may have been unable to acknowledge the drayon. Valid characters are in the range: Some characters may require more than one key pressed simultaneously during normal use refer to the manual of your PC or terminal for keyboard use. New enhanced architecture, based on an M16 high-speed microprocessor, enables exceptional performance for promptness and reading speed of standard codes as well as the ability to read poorly printed and damaged codes.

Datalogic Dragon D – Barcode Scanner | eBay

In such cases it may be better to disable single store so that the user perceives a more consistent behavior of the trigger in that it always corresponds to code reading.

The keys must be set in a specific order. Address Stamping m Series Only Purchaser shall not d1131 or alter any proprietary notices, including copyright notices, contained in d1331 documentation and shall ensure that all notices appear on any reproductions of the documentation.